Hand Shocker Bones Embroidered Patch Badge Iron on or Sew On.

Hand Shocker Bones Embroidered Patch Badge Iron on or Sew On.

Stock Status : In Stock
Product Condition:   New
Iron on or Sew no


Hand Shocker Bones Badge Iron on or Sew On.

95 x 55 Millimetres
9.5 x 5.5 Centimetres
3.74 x 2.16 Inches

The patch has a heat seal backing which allows you to just iron it onto a garment or bag etc of your choice.

1. Turn your iron to the hottest setting your garment / bag etc can tolerate. Ensure the "STEAM" option is turned OFF, and that your iron IS NOT full of water.

2. Place your item on a flat, heat-resistant surface like an ironing board. Ensure the item is flat providing a good surface for the patch; you may need to iron the item first.

3. Peel off the paper backing and place the patch in position, the adhesive side should be flat against the fabric.

4. Place a thin cloth /towel over the patch. When doing this ensure you take care not to disturb the position of the patch.

5. Position the hot iron over the patch and press down firmly. Hold the iron there for about 10seconds

6. Remove the iron and allow the patch to cool.

7. Lift the towel and check to see whether the patch is fixed on securely.

8. If it has not fixed to the item, replace the towel and press the iron on again for a further 10 seconds.

Write an online review and share your thoughts with other shoppers!

Be the first to review this product

Copyright RLK Print and Embroidery All rights reserved.

Can't find what you're looking for? Search Here or get in Touch!